Data AcQuisition And Real-Time Analysis
Scope - Spectrum - Spectrogram - Signal Generator
Software for Windows
Science with your Sound Card!
The following is from the Daqarta Help system:



Spectrum Analyzer

Signal Generator

(Absolutely FREE!)


Pitch Tracker


DaqMusiq Generator
(Free Music... Forever!)

Engine Simulator

LCR Meter

Remote Operation

DC Measurements

True RMS Voltmeter

Sound Level Meter

Frequency Counter
    Spectral Event

    MHz Frequencies

Data Logger

Waveform Averager


Post-Stimulus Time
Histogram (PSTH)

THD Meter

IMD Meter

Precision Phase Meter

Pulse Meter

Macro System

Multi-Trace Arrays

Trigger Controls


Spectral Peak Track

Spectrum Limit Testing

Direct-to-Disk Recording



Frequency response

Distortion measurement

Speech and music

Microphone calibration

Loudspeaker test

Auditory phenomena

Musical instrument tuning

Animal sound

Evoked potentials

Rotating machinery


Product test

Contact us about
your application!

Macro List

Controls: Options Menu >> Macro Dialog >> Macro List

This list box contains all the macros currently loaded. (See Macro Examples and Mini-Apps for those included in the default Daqarta installation.) If there are many macros, you may need to scroll down to see them all.

In general, you can run any macro by double-clicking it. A single click will cause that macro to be selected into the ID box below the list, but will not run it unless you hit the Run button or press the Enter key.

The list is sorted by ID such that digits appear first, then letters, then punctuation. Note that letters are case-sensitive.

At the end of the list are macros without IDs, sorted by Name. These macros can't be invoked as hot-keys, but can be used as building blocks to construct more-complex macros. They can also be invoked individually by double-clicking the list entry. Note, however, that many of these are only intended for use by other macros, not to be run on their own.

Accessibility: Although the List is at the top of the Macro Dialog, it is not included in the default Tab order. To move the keyboard focus to the List, hit SHIFT+Tab from the ID field (the default when the dialog opens). The keyboard focus will move to the currently-selected macro in the List. You can use the Up and Down arrow keys to move the selection. Hitting Enter will run the selected macro. To open the Edit dialog from the List, hit Tab 5 times and hit Enter. (The tab motion from List is ID, Run, Step, New, Edit... Halt and Cancel are disabled when no macro is running.)

See also Macro Dialog, Macro Overview


Questions? Comments? Contact us!

We respond to ALL inquiries, typically within 24 hrs.
Over 35 Years of Innovative Instrumentation
© Copyright 2007 - 2023 by Interstellar Research
All rights reserved