Sine Wave - Generator

Controls: Gen Dlg >> Stream >> Wave >> Sine
Macro: Wave=Sine

Standard sinusoidal waveform. This is a simple button; there is no separate dialog. Use the Tone Freq dialog to set the phase of one stream to 90 (or -90 = 270) degrees if you want both sine and cosine waves.

Note that there is a special trick using Burst to get precision frequency control at very low values (fractional Hz), where the normal Tone Frequency control is too coarse. See Jitter-Free Square Waves - Burst Method under Square Wave, and follow it to the end of the topic.

See also Wave Dialog.